DT Research DT430 Guía de usuario descargar pdf (Pagina 34)

Rev Date 9/16/2010

Using the Barcode Scanner

Before using scanner, user needs to run the Scanner Configure program to make sure the target barcode symbology is

selected. By using the Scanner Configure program, user can add, delete or reset symbology.

Note

Before executing the Scanner Configure program, make sure to disconnect the scanner in

the Keyboard Wedge.

Configuring a Scanner

To configure the scanner module settings:

Run

ScannerConfig.exe

Tap

Start → Programs → Scanner Configure

. A dialog box is

displayed and the COM port settings have been displayed as right

figure.

2D Scanner Module

COM1

for

Port

for

Stop bits

57600

for

Baud

rate

None

for

Parity

for

Data bits

1D Scanner Module

COM1

for

Port

for

Stop bits

19200

for

Baud rate

None

for

Parity

for

Data bits

Click on the

Connect

button to activate the scanner module.

After connecting to the scanner module, the Firmware version, Available symbologies and Symbologies in used will be

displayed on the screen. User can check if the target symbology is listed in the Symbologies in used listbox. If yes, click the

OK button to finish the scanner configuration. If not, select the target symbology in the Available symbologies listbox and

click the “

Add” button. The selected target symbology will be added into the Symbologies in used listbox. Then click the

OK button to finish the scanner configuration.

Note

Adding only the symbologies you need for testing will give the best results.

Adding too many symbologies all at the same time will influence performance.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40 41

Comentarios a estos manuales

Sin comentarios

DT Research DT430 Guía de usuario Pagina 34

Comentarios a estos manuales

Relacionado con productos y manuales para Terminales Punto De Venta DT Research DT430